Replacing The Light Bulb - arietta ALS436SS Guía De Instrucciones Para Instalación

Replacing the halogen lamp
CAUTION: Before replacing the lamps, disconnect power off
to prevent from being switched on accidentally.
Turn off the range hood and allow the halogen / incandescent
lamp to cool. To avoid damage or decreasing the life of the new
bulb, do not touch bulb with bare fingers. Replace bulb, using
tissue or wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
■ Disconnect power.
■ Use a flat-blade screwdriver and gently pry the light cover
loose.
■ Remove the lamp and replace with a 120-volt, 40-watt
maximum, halogen lamp made for a G-9 base.
■ Replace the light cover.
■ Reconnect power.
Cleaning
■ Always use the mildest cleaner that will do the job. Use clean,
soft cloths, sponges or paper towels.
■ Rub stainless steel finishes in the direction of the grain. Wipe
area dry to avoid water marks.
■ After cleaning, place all parts in their proper positons before
using.
■ The cleaners recommended below indicate a type and do not
constitute an endorsement. Use all products according to
package directions.
Hood Surface
Stainless Steel Surfaces: Wipe and dry stainless steel in the same
direction as the grain. Avoid using too much pressure, which may
mar the surface. To remove finger prints and give added shine,
use cleaners such as Stainless Steel Magic. Do not allow any
cleaning compounds to remain in contact with stainless steel for
extended periods.
Plastic Surfaces: Wipe with a moist soapy sponge. Rinse and dry.
Aluminum Mesh Filters: Clean filters in the dishwasher or by
agitating in sudsy water. Ensure that there is no soil trapped in the
fine mesh. Dry the filters before reinstalling them.
Optional Recirculating Kit
■ If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filters that help
remove smoke and odors.
■ The charcoal filters cannot be cleaned.
■ They must be replaced.
■ The charcoal filters are clipped inside of each metal grease
filter (mounting instructions included with recirculating kit mod.
KIT01937).
■ The charcoal filters should be replaced every 4-6 months
(depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an automatic
dishwasher.
10