Theoretical Length Of Cut - Nogueira FTN-2500 Manual De Instrucciones

4. Preparation

4.9- Theoretical length of cut

Different cutting sizes can be obtained,
changed according to the gears used and
the number of chopper rotor knives. Possible
sizes range from 3 to a maximum of 22 mm.
The table below shows the possible cuts, their
gear pairs and the number of knives required
to obtain each size.
How to change the chopped size:
ATTENTION!
Turn off the tractor and remove
the ignition key before starting
the following procedure.
Remove the cover (B) from the cutter set
1.
box;
Note in the table above which pair of gears
2.
should be mounted to obtain the desired
chop size
Change the gears (C);
3.
Replace the gearbox cover, the nuts and
4.
the washers (C);
64
Cutting gears
Instructions Manual
B
C