Theoretical Length Of Cut - Nogueira FTN-1000 Super G2 Manual De Instrucciones

4.1- Theoretical length of cut

Different cutting sizes can be obtained,
changed according to the gears used and the
number of chopper rotor knives. Possible sizes
range from 2.5 to a maximum of 18 mm.
The table below shows the possible cuts, their
gear pairs and the number of knives required
to obtain each size.
How to change the chopped size:
ATTENTION!
Turn off the tractor and remove
the ignition key before starting
the following procedure.
Remove the 4 bolts (A) and the cover (B);
1.
Loosen the tensioner bolt (C);
2.
Loosen and remove the chain (D);
3.
Remove the bolt (G) and the sprocket
4.
wheel (H);
Remove the 2 bolts (J) and the cover (K);
5.
CHOPPING CHANGE
B
Instructions Manual
4. Preparation
A
C
D
J
G
J
H
K
45