Theoretical Length Of Cut - Nogueira FTN-1900 Manual De Instrucciones

4.10- Theoretical length of cut

Different cutting sizes can be obtained,
changed according to the gears used and
the number of chopper rotor knives. Possible
sizes range from 2 to a maximum of 36 mm.
The table below shows the possible cuts, their
gear pairs and the number of knives required
to obtain each size.
How to change the chopped size:
ATTENTION!
Turn off the tractor and remove
the ignition key before starting
the following procedure.
Remove the cover (B);
1.
Loosen the tensioner bolt (C);
2.
Remove the chain (D);
3.
Remove the bolt and washer (E);
4.
Remove the sprocket gear (F);
5.
Note in the table above which pair of gears
6.
should be mounted to obtain the desired
chop size;
Change the gear pair (G), as indicated in
7.
the table.
Instructions Manual
4. Preparation
G
B
E
D
F
C
G
65