Franke SMART PLUS SGP 62 M Serie Manual De Instalación Y Servicio página 11

SGP 62 M _/F / SMP 62 M _/F / SMP 66 M _/F / CF 65 M _/F
Setting the digital clock
When the appliance has been connected to the
mains or after a power failure the display will
flash on: „0.00".
X X
Press the + and - buttons together for a few
seconds. The time of day can be adjusted
with the + and - buttons, while the dot
between the hours and minutes flashes.
B
„ „
If the time setting mode is selected
when an automatic programme is
active, the automatic programme is
cancelled.
Possible time adjustments can be made by
repeating the steps described above.
Acoustic signal frequency modification
The frequency of the acoustic signal can be
changed if a cooking cycle is not programmed
(therefore the display shows the time of day).
X X
Press the + and - buttons (from the time
modification menu) together.
X X
Press Mode or Set to select the menu for
modifying the acoustic signal frequency.
X X
The acoustic signal frequency can be
modified by repeatedly pressing the Mode
or Set button; „ton1", „ton2", „ton3" will
appear on the display.
Manual oven operation
Once the time has been set, the programmer
automatically switches to manual mode.
Starting delayed cooking with set
duration
X X
When the time of the day is displayed,
press the Mode or Set button twice to set
a duration.
X X
Then press it again to set the end of
cooking time.
X X
Set the required time with the + and -
buttons.
„ „
During duration or end time
adjustment mode selection, the Auto
symbol remains lit.
„ „
Once a programme duration is set, the
end time cannot be decreased.
„ „
Likewise, the duration of a programme
cannot be prolonged once the end
time is set.
„ „
The end time and duration settings
define programme start time as
follows:
start time = end time - duration.
„ „
After setting the duration and end
time, the display still shows the
end time.
„ „
The programme starts when the time
of day coincides with the start time:
the Auto symbol lights up steadily and
the symbol
„ „
After the start of cooking, the display
shows the countdown. If only the
end of cooking time is selected (the
duration is = 0), cooking starts and the
display shows the countdown.
The Auto symbol remains lit during the
„ „
wait for delayed start and for the entire
duration of cooking.
„ „
The symbol
for delayed start and remains fixed
when cooking starts.
„ „
An acoustic signal sounds at the end
of cooking; to silence it, press any
button or allow the signal to continue
for its duration.
Semiautomatic programme with
duration or end time
Programme time setting
X X
To select the programme duration or end
time press the Mode or Set button twice
and set the required time with the + and –
buttons.
„ „
During duration or end time adjustment
mode selection, the corresponding Auto
symbol flashes.
– 11 –
starts flashing.
flashes during the wait
EN