Mettler Toledo IND246 Guia De Instalacion página 28

2-6 METTLER TOLEDO IND246 and IND246 POWERCELL Installation Manual
Figure 2-7: Preparing to Detach Front Panel
3. Unplug the power connector from the main board (Figure 2-8).
4. Loosen and remove the two nuts securing the two hinge/grounding straps that connect the
front panel to the rear housing.
5. Remove the load cell cable gland from the rear of the enclosure and reinstall it into the
same sized opening at the other side of the enclosure (where the AC cable gland was
located in the AC model). the plug in the enclosure must be removed. Tighten the gland to
2 N-m (18 lbf-in).
6. Carefully rotate the housing 180 degrees and use the nuts removed in step 4 to reattach
the two grounding straps to the studs near the grip bushings (Figure 2-9). Tighten the two
nuts.
Figure 2-8: Battery Power Connector
Attachment studs
Power connector
64084463 | 03 | 12/2017