Installation; Opening The Enclosure - Mettler Toledo IND246 Guia De Instalacion

2

Installation

This chapter covers
•

Opening the Enclosure

•
Environmental Protection
•
Mounting the Terminal
•
Installing Cables and Connectors
•
PCB Switch Settings
•
PCB Jumper Positions
•
SD Card Installation
•
Capacity Label Instructions
•
Closing the Enclosure
•
Securing the Enclosure
2.1. Opening the Enclosure
The front panel of the harsh enclosure IND246 terminal is locked in place by four spring clips
attached to the body of the enclosure. To access the terminal's PCB to install options, connect
internal wiring and set switches, separate the front panel from the enclosure as follows:
64084463 | 03 | 12/2017
This Appendix provides installation instructions for the IND246 and IND246
POWERCELL terminals. Please read these procedures thoroughly before beginning
installation.
This section includes details about opening and mounting the enclosure and explains
how to install any cables to the enclosure. Instructions for labeling, closing and
sealing the enclosure are also provided.
1. Insert the tip of a flat-blade screwdriver into one of the two slots located on the bottom of
the front panel assembly (see Figure 2-1). While squeezing the front panel and enclosure
together, gently push the screwdriver in toward the enclosure. A "pop" sound is made when
the cover clip is released.
Be certain to squeeze the front panel and enclosure together when pressing the clips. This
removes pressure from the clips, allowing them to release.
Figure 2-1: Opening the Harsh Enclosure
METTLER TOLEDO IND246 and IND246 POWERCELL Installation Manual 2-1