Mettler Toledo IND246 Guia De Instalacion página 63

64084463 | 03 | 12/2017
2. With the front panel installed on the enclosure and snapped into place, thread the free end
of the wire seal through either the left or right hole in the IND246 front panel, and through
the hole in the retaining clip.
3. Thread the end of the wire cable through the hole in the plastic seal (as shown in Figure
2-74), remove any remaining slack in the wire, and snap the seal shut.
Sealing wire
threaded through
hole and clip
Sealing wire
threaded through
plastic seal
Figure 2-77: Seal Threaded and Ready to be Closed
METTLER TOLEDO IND246 and IND246 POWERCELL Installation Manual 2-41