Assigning Ip Address And Subnet Mask; Manual Ip Address Assignment With Address Switch - Aventics AES Serie Descripción De Sistema

96 AVENTICS | Bus Coupler AES/Valve Driver AV, EtherNet/IP | R412018139–BAL–001–AF
Presettings on the Bus Coupler
Address on delivery
S1
S2
9.3

Assigning IP address and subnet mask

The bus coupler requires a unique IP address in the EtherNet/IP network in order to be detected by
the controller.
On delivery, the switches are set to DHCP function (0x00). Switch S2 is set to 0 and switch S1 to 0.
9.3.1

Manual IP address assignment with address switch

Fig. 5: Address switches S1 and S2 on the bus coupler
The two rotary switches S1 and S2 for manual valve system IP address assignment are located
underneath the window (3).
Switch S1: The higher nibble of the last block of the IP address is set at switch S1. Switch S1 is
labeled using the hexadecimal system from 0 to F.
Switch S2: The lower nibble of the last block of the IP is set on switch S2. Switch S2 is labeled
using the hexadecimal system from 0 to F.
The rotary switches are set to 0x00 by default. This activates address assignment via DHCP server.
Proceed as follows during addressing.
Ensure that each IP address exists only once on your network and note that the address 0xFF
or 255 is reserved.
1. Disconnect the bus coupler from the power supply UL.
2. Set the station address at the switches S1 and S2 (see Fig. 5). For this, set the rotary switch to
a position between 1 and 254 for decimal or 0x01 and 0xFE for hexadecimal:
– S1: High nibble from 0 to F
– S2: Low nibble from 0 to F
3. Reconnect the power supply UL.
The system will be initialized and the address applied to the bus coupler. The IP address of the
bus coupler is set to 192.168.1.xxx, where "xxx" corresponds to the setting of the rotary switch.
The subnet mask is set to 255.255.255.0 and the gateway address to 0.0.0.0. Address
assignment via DHCP is deactivated.
S1
S1
S2
S2
3