Kärcher B 110 R Manual De Instrucciones página 14

Release lever
1
2. Insert a coin between the housing and the lever at both
ends of the lever.
3. Let go of the release lever.
4. Push the device.
5. Remove both coins immediately after pushing.
Adjusting the seat
Adjusting the height
1. Stand next to the device.
2. Raise the seat at the back.
3. Align the front seat bracket to the desired height of the
device.
4. Lower the seat at the back.
Adjusting the position
1. Operate the seat adjustment lever and move the seat to
the desired position.
2. Release the seat adjustment lever and latch the seat in-
to position.
Switch on the device
1. Get in the driver's seat.
2. Insert the Intelligent Key.
3. Set the safety button to position "1".
4. Turn the program switch to the desired function.
5. If one of the indications below appears in the display,
take your foot off the accelerator pedal, set the safety
button to "0" and carry out the necessary maintenance
work.
Display Activity
maintenance Clean the suction bar.
squeegee
maintenance Check the brushes for wear and
brush head clean them.
maintenance Check the suction lips for wear and
squeegee blade adjustment.
maintenance Clean the fluff filter.
turbine filter
maintenance Clean the filter with fresh water.
fresh water filter
6. Press the info button.
7. Reset the counter for the corresponding maintenance
(see "Gray Intelligent Key/Reset Maintenance Count-
er").
Note
If the counter is not reset, the maintenance indicator will re-
appear each time the device is turned on.
14
Switching on the light
The daytime running light is in operation when the device
is switched on.
The sidelight lights up as soon as the program switch is set
to a cleaning program.
Check parking brake
DANGER
Defective parking brake
Danger of accident
Before each operation, check the function of the parking
brake on level ground.
1. Switch on the device.
2. Set the travel direction to "forward".
3. Set the program switch to "TRANSPORT MODE".
4. Press the accelerator pedal lightly.
The brake must release audibly. The device must roll off
easily on the level.
5. Release the accelerator pedal.
The brake must engage audibly.
If this is not the case, put the device out of operation and
call the customer service.
DANGER
Lack of braking effect
Accident risk
Be sure to check the parking brake before using the de-
vice. Never use the device if the parking brake is not work-
ing.
DANGER
Careless driving
Danger of tipping over
Only drive in the direction of travel and across the direction
of travel on gradients up to maximum of 10%.
Do not turn on gradients.
Drive slowly in corners and on wet ground.
Only drive the device on stable ground.
Note
The travel direction can be changed during the journey op-
eration. This allows very dull spots to be polished by mov-
ing back and forth several times.
1. Assume the sitting position.
2. Insert the Intelligent Key.
3. Set the safety button to "1".
4. Set the program switch to "TRANSPORT MODE".
5. Set the travel direction using the travel direction switch
on the control panel.
6. Determine the travel speed by pressing the travel pedal.
7. Release the accelerator pedal.
The device stops.
In case of overload, the engine is switched off. A fault mes-
sage appears in the display. If the control overheats, the af-
fected engine is switched off.
8. Allow the device to cool down for at least 15 minutes.
9. Set the program switch to "OFF", wait briefly and set to
the desired program.
English
Daytime running light
Sidelight
Driving