Operation; Pushing The Device - Kärcher B 110 R Manual De Instrucciones

and an adequate air exchange rate with a minimum air flow
(see "Recommended batteries").
ATTENTION
Accumulation of dangerous gases under the tank
during the charging process
Risk of explosion
Pivot the waste water tank upwards before charging low-
maintenance batteries.
The average charging time is approx. 10-15 hours.
The device cannot be used during the charging process.
Note
The device has deep discharge protection, i.e. the brush
motor and turbine are switched off automatically when the
permitted minimum capacity level is reached.
1. Drive the device directly to the charger and do not drive
on slopes.
External charger
ATTENTION
Using an unsuitable charger
Risk of damage
Do not connect the charger to the device-side battery con-
nector.
Use only a charger suitable for the type of battery installed.
Read the operating instructions of the charger manufactur-
er and observe the safety instructions in particular.
Battery Capacity
4.039-352.7 170 Ah
4.039-354.7 180 Ah
4.039-353.7 285Ah
1. Unlock the waste water tank and pivot it to the rear.
2. Pull out the device-side battery connector.
Battery plug, device side
1
Battery plug, battery side
2
3. Connect the battery-side battery connector to the char-
ger.
4. Plug the mains plug of the charger into the socket.
5. Carry out the charging process in accordance with the
operating instructions for the charger.
6. Connect the device-side battery connector to the bat-
tery-side battery connector.
7. Pivot the waste water tank forwards and close it.
1. Unlock the waste water tank and pivot it to the rear.
2. Plug the mains plug of the internal charger into the
3. Unplug the charger mains plug from the mains socket
4. Pivot the waste water tank forwards.
Refilling discharged batteries with water
Danger of acid burns from escaping acid, destruction of
clothes
Wear safety goggles, protective clothing and protective
gloves when handling the battery acid.
Observe the applicable regulations.
Immediately rinse off any splashed acid from the skin or
clothes using copious amounts of water.
ATTENTION
Using water with additives
Defective batteries, loss of warranty claim
Top up the batteries using only distilled or desalinated wa-
ter (EN 50272-T3).
Do not use any foreign additives, so-called enhancing
agents, because this will invalidate the warranty.
Charger
1. Add distilled water one hour before the charging pro-
6.654-436.0
6.654-434.0
6.654-419.0
2. Clean up any spilled water. To do this, proceed as de-
Falling objects
Danger of injury
Do not drive the device into areas where there is a possi-
bility of the operating personnel being hit by falling objects.
ATTENTION
Risks during operation
Danger of injury
In the event of danger, set the safety button to "0".
To push the device, the brake must be unlocked.
Danger of accident
When the brake is unlocked, the function of the brake is
permanently out of operation.
Be sure to remove the coins for unlocking immediately af-
ter pushing.
1. Pivot the release lever away from the wheel and hold it
English
Internal charger
mains socket.
The charging state of the battery is shown on the control
panel display.
after the charging process.
Low-maintenance batteries (wet batteries)
DANGER
cess comes to an end. Observe the correct acid level
according to the battery label.
All cells must produce gas at the end of the charging
process.
scribed in the "Cleaning the batteries" section in the
Care and Maintenance chapter.

Operation

DANGER

Pushing the device

DANGER
there.
13