Gray Intelligent Key - Kärcher B 110 R Manual De Instrucciones

6. Close the water inlet.
7. Disconnect the water supply hose from the device.
8. Close the waste water drain hose and press it into the
holder.
Empty the coarse dirt container
1. Lift the coarse dirt container and pull it out.
2. Empty the coarse dirt container.
3. Reinstall the coarse dirt container.
Draining fresh water
1. Open the fresh water tank cap.
2. Drain the fresh water.
3. Clean the filter.
4. Fit the fresh water tank cap.
Shutting down the device
1. Turn the program switch to "OFF".
2. Remove the Intelligent Key.
3. Secure the device against rolling away.
4. Open the lid of the waste water tank and secure it with
the support so that the waste water tank can dry out. To
do this, swing the support down and position the lower
end at the desired level when swinging down the cover.
Waste water tank cap
1
Support
2
Level
3
5. Charge the batteries if necessary.

Gray intelligent key

The gray Intelligent Key grants the supervisory staff ex-
tended authorizations and setting options.
1. Insert the Intelligent Key.
2. Select the desired function by turning the info button.
Transport trip
1. Set the program switch to "TRANSPORT MODE".
2. Press the info button.
The following functions can be performed in the TRANS-
PORT MODE menu:
● Set maximum speed
● Display operating hours counter
● Delete maintenance counter
● Show software versions
● Set R or D cleaning head
● Switch speed-dependent water dosing on/off
● Set after-running times
● Set language
● Key management
● Switch attachment kits on/off
● Activate factory setting
In the menu "max speed" the maximum speed can be lim-
ited.
1. Turn the info button until "max speed" is shown in the
display.
2. Press the info button.
3. Turn the info button until the desired maximum speed is
displayed.
4. Press the info button.
Note
The working speed cannot exceed the set maximum
speed.
Resetting the maintenance counter
If a maintenance task shown in the display has been car-
ried out, the corresponding maintenance counter must
then be reset.
1. Turn the info button until "maintenance count." is dis-
played.
2. Press the info button.
The meter readings are displayed.
3. Rotate the info button until the counter to be deleted is
highlighted.
4. Press the info button.
5. Select "yes" by rotating the info button.
6. Press the info button.
The counter is deleted.
Adjusting the cleaning head
1. Turn the info button until "brush head" is displayed in the
menu.
2. Press the info button.
3. Turn the info button until the type of cleaning head in-
stalled is highlighted.
"Roll" = R cleaning head
"Disc" = D cleaning head
4. Press the info button.
Speed-dependent water dosing
If the speed-dependent water metering is switched on, the
brush watering changes proportionally with the speed.
The water dosage is additionally influenced by the setting
of the respective cleaning program (0...100%).
Setting
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
Set speed-dependent or constant water dosing:
1. Turn the info button until "water dosage mode" is shown
in the display.
2. Press the info button.
3. Turn the info button until the desired function is
marked...
4. Press the info button.
English
Maximum speed
2
ON [ml/m ] OFF [l/min]
0 0
7.5 0.675
15 1.35
22.5 2.025
30 2.7
37.5 3.375
45 4.05
52.5 4.725
60 5.4
67.5 6.075
75 6.75
17