Initial Startup; Charging The Battery - Kärcher B 110 R Manual De Instrucciones

Ocultar thumbs Ver también para B 110 R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Description
Order no.
285Ah - Main-
4.039-353.7
tenance-free,
AGM
* Minimum volume of battery charging room
** Minimum air flow between battery charging room and
environment
Installing and connecting batteries
CAUTION
Removing and installing the batteries
Unstable machine position
Ensure that the machine is positioned stably when remov-
ing and installing the batteries.
ATTENTION
Incorrect connection polarity
Destruction of the control electronics
Take care to ensure the correct polarity when connecting
the batteries.
ATTENTION
Deep discharge
Risk of damage
Charge the batteries before starting the device.
1. Drain the waste water.
2. Unlock the waste water tank and pivot it to the rear.
3. Place the battery in the device.
170 Ah, 4.039-352.7
Spacer 310x85x70 mm
1
Spacer 240x55x30 mm
2
180 Ah, 4.039-354.7
12
Volume
Airflow (m
3
(m
)*
h)**
12.6
5.1
English
3
Spacer 310x85x70 mm
/
1
285 Ah, 4.039-353.7
Spacer 345x60x47
1
4. Insert the spacers at the locations shown in the picture
between the battery and the device.
5. Connect the battery terminals using the connecting ca-
bles.
6. Clamp the connecting cable on the (+) and (-) battery
terminals that are still free.
Note
For the 170 Ah 4.039-352.7 battery set, attach the connec-
tion cable to the negative pole with the insulated pole
screw.
7. Connect the device-side battery connector to the bat-
tery-side battery connector.
8. Pivot the waste water tank forwards and close it.
Removing the battery
CAUTION
Removing and installing the batteries
Unstable machine position
Ensure that the machine is positioned stably when remov-
ing and installing the batteries.
1. Set the safety button to "0".
2. Drain the waste water.
3. Unlock the waste water tank and pivot it to the rear.
4. Pull out the battery plug.
5. Disconnect the cable from the minus terminal at the bat-
tery.
6. Disconnect the remaining cables from the battery.
7. Remove the battery.
8. Dispose of the used batteries in accordance with statu-
tory provisions.

Charging the battery

DANGER
Inappropriate use of the charger
Electric shock
Adhere to the mains voltage and fuse values specified on
the device type plate.
Only use the charger in dry rooms with sufficient ventila-
tion.
Flammable gases are generated when the battery is
charged
Risk of explosion
Only charge the battery in a suitable room. The room must
have a minimum volume depending on the battery type

Initial startup

Publicidad

Tabla de contenido
loading

Tabla de contenido