Kärcher B 110 R Manual De Instrucciones página 22

Malfunction
blocked side brush
waste water tank full
overload drive motor
blocked drive motor
battery low
battery empty
seat switch open
switch on!
restart machine
release throttle
Malfunction
The device cannot be
started
The device no longer
moves, display shows
"battery empty"
The device moves uneven-
ly (jerks) when starting
and stopping.
The fresh water display
shows the wrong filling
level after manual tank
emptying
The bar of the filling level
display flashes, display
"fresh water empty"
22
Rectification
1. Check whether a foreign object is blocking the brush, remove the foreign object if neces-
sary.
2. Set the program switch to "OFF".
3. Wait 10 seconds.
4. Set the program switch to the desired program.
1. Empty the waste water tank.
1. The slope is too steep.
a For cleaning operation: Cancel cleaning.
b For transport travel: Find a path with a lower gradient.
1. Check the wheels for blockage, remove foreign bodies.
2. Set the program switch to "OFF".
3. If the engine is overheated, allow it to cool down for at least 15 minutes, otherwise wait
10 seconds.
4. Set the program switch to the desired program.
1. Set the program selector switch to TRANSPORT MODE.
2. Drive the device directly to the charger (or to the socket in the case of an internal char-
ger). Avoid inclines.
3. Charge the battery.
1. Set the program selector switch to TRANSPORT MODE.
2. Drive the device to the charger (or in the case of an internal charger, to the socket) by the
shortest route. Avoid inclines.
3. Charge the battery.
1. Briefly relieve the driver's seat so that the control can check the function of the seat con-
tact switch.
1. Set the safety button to "1".
1. Set the program switch to "OFF".
2. Wait 10 seconds.
3. Set the program switch to the desired program.
1. Release the accelerator pedal.
Faults not shown in the display
Rectification
1. Sit in the driver's seat.
2. Take your foot off the accelerator before switching on the safety button.
3. Turn the safety button to "1".
4. Check the battery and charge if necessary.
5. Set the program switch to "OFF".
6. Wait 10 seconds.
7. Set the program switch to the desired program.
8. If possible, only drive the device on level ground.
9. Check the parking brake if necessary.
If the fault still occurs, call Customer Service.
1. Set the program switch to "OFF".
2. Wait 10 seconds.
3. Set the program switch to "TRANSPORT MODE".
4. Drive to the charging station.
5. If the device still does not move, charge the battery on site or unlock the brake (see "Op-
eration/Pushing the Device") and push the device to the charging station.
1. Reverse the brake release (see "Operation/Pushing the device").
1. Use device. During operation, the hose system vents and the filling level display corrects
itself.
1. Refill the fresh water tank.
English