Proper Use; Putting Into Operation - Brill 32 EH Manual Del Usuario

4. Notes on Operating Instructions
Please read the operating instruc-
tions carefully and follow the
instructions contained in them and
in the safety instructions enclosed.
Please use the operating instruc-
tions to familiarise yourself
with the equipment, the adjusting
components, correct use of
the equipment and the safety
instructions.

5.Proper Use

The Brill lawnmower is intended
for cutting lawns and areas of
grass in domestic gardens and
allotments and not for commercial
use in public areas, parks, sports
stadia, on streets and in agriculture
and forestry.
Adherence to the instructions for
use enclosed by Brill is a precondi-
tion for the proper use of the
6. Assembly
Check for completeness
The box contains the following
components
Lawnmower
.
Grass box
.
1 Upper part of guide bar
.
(handle with switch)
2 lower parts of guide bar
.
Fixing components for guide bar
.
Operating instructions
.
List of Service Centres
.

7. Putting Into Operation

Setting the Cutting Height
Figure 2
The cutting height is set centrally
with a rotating knob and the height
is infinitely variable.
Warning! Never allow
A
children or other people
who have not read these operating
instructions to use the lawn-
mower. Local regulations may set
a minimum age for the user.
Never mow grass when people,
especially children, or animals are
in the area. Remember that the
equipment. The instructions for use
also include the operating, care
and maintenance instructions.
Warning! The mower must
A
not be used for trimming
bushes, hedges and herbaceous
plants, for cutting and chopping
weeds or for mowing lawns on
rooftops or in balcony boxes
because of the risk of physical
Assembling the Guide Bar
Figure 1
Insert the lower guide bar into the
holders in the housing on both
sides so that the smooth side points
outwards. Then screw in the bar
with the knurled bolts supplied
(figure 1, item 1). The bar with the
switch is inserted from outside into
the channels provided for the pur-
pose and screwed to the lower bar
with the knurled bolts and nuts
The cutting height set can be
read off the display in 5 mm
graduations.
Warning! Only set the cut-
A
ting height with the motor
turned off.
person in charge of the machine or
the user is responsible for accidents
involving other people or property.
Keep these operating instructions
in a safe place.
injury. Moreover, the machine
may not be used as a shredder
for cutting up tree and hedge
trimmings or for rolling out uneven
areas of ground.
Only use permitted extension
cables made of PVC with the
coding H05 RN-F or H05 VV-F with
a maximum length of 15 m.
provided (figure 1, item 2).
Ensure that the cable runs on the
outside along the bar and is not
trapped.
Fasten the cable by pushing the
clamp on to the lower part of the
bar from outside (figure 1, item 3).
Only set the cutting height
to a depth where the blades
of the cutting mechanism do
not touch the ground if it is
uneven.
GB
23