Instructions For Correct Use, Safety Instructions - Brill 32 EH Manual Del Usuario

Fault
GB
Aerator roller is not operating
with the blade (only 32 EH).
Lawn turns yellow,
cut uneven.

11. Instructions for Correct Use, Safety Instructions

Check each time you use
A
the mower
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices (switch
handle, safety covers) and / or if
the cutting device is damaged or
worn. Never disable safety devices.
Check the area to be mowed
before starting work. Remove any
foreign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear strong shoes and
long trousers whilst working.
Do not mow barefoot or in light-
weight sandals.
Check the cutting tools regularly for
damage and have them repaired
correctly if necessary.
Only have cutting tools replaced
by Brill Service or your authorised
specialist dealer.
Use / Responsibility
A lawnmower can cause serious
injuries! You are responsible for
safety in the area where you are
working. Never start the mower
whilst tilted – risk of injury!
Always use the mower solely
for the purpose described in the
operating instructions.
28
Possible cause
Rotary switch at 0 position.
V-belt torn.
Blade too blunt, cutting height
too low.
Only mow in daylight or with ade-
quate artificial lighting.
Ensure that you are standing
safely and on firm ground, even
on a slope. Mow across the slope,
never up and down. Do not mow
excessively steep slopes. Be careful
if you change direction on a slope,
turn the machine round or draw
it towards you.
Be careful if you are going back-
wards, risk of stumbling!
Only push the mower at walking
pace.
Turn the motor off if the mower has
to be tilted when transporting it
over surfaces other than grass and
if you are transporting the mower
backwards and forwards to the
area to be mowed.
Never use the machine with
damaged protective devices or
without protective devices.
Disconnect all the cutting tools and
drives before you start the motor.
When starting or operating the
starter switch take care as
stipulated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the cut-
ting tool.
When starting or switching on the
motor, the machine should not be
Solution
Turn rotary switch to 1 with
the motor switched off.
V-belt must be replaced by
specialist workshop.
Change or turn blade,
set cut somewhat higher .
tilted unless the machine has to be
raised during the process. In this
case only tilt it as far as absolutely
necessary and only raise the side
away from you.
Do not start the motor when
you are standing in front of the
discharge duct.
Keep your fingers and feet away
from the cutting tool!
Never lift or carry a machine with
the motor running.
Each time you have to work on
the machine or leave it or top it up,
always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Unplug from the mains.
Remove the obstacle, check the
mower for any damage and have
it repaired if necessary.
If the mower begins to vibrate
strongly, unplug from the mains
and ascertain the cause.
A
Taking a Break
Never leave the lawnmower unat-
tended. If you stop work, unplug
the mower from the mains and
store the mower in a safe place.