Disposal - MIETHKE proGAV 2.0 Instrucciones De Manejo

EN | INSTRUCTIONS FOR USE
Mechanical alkaline cleaning and thermal disinfection
Phase I
Clean product in the ultrasonic cleaning bath (frequency 35 kHz). Ensure that all accessible
surfaces are wetted.
Phase II
Fully rinse/flush product (all accessible surfaces) under running water.
Device type: Single chamber cleaning/disinfection device without ultrasound
Place product on suitable screen basket (avoid missed areas)
Phase I
Step
Pre-
rinsing
T (°C/°F)
< 25/77
t (min)
3
Water
D-W
quality
Chemical
-
specifi-
cations
D-W: Drinking water, P-W: Purified water demineralised
Checking, maintenance, testing
Allow product to cool down to room tem-
perature.
Check product after each cleaning and dis-
infection for:
Cleanliness, functioning and damage, e. g.
insulation, loose, bent, broken, cracked,
worn and detached parts.
Discard damaged products immediately.
After the cleaning process, it is recom-
mended to place the instrument inside a
suitable double sterile packaging. This will
ensure reuse in the best way possible.
28
II III
Cleaning Neutralisation
55/131 20/68
10 2
P-W P-W
Concentration, Concentration,
alkaline: acidic:
pH = 10.9 < 5% pH = 2.6;
anionic surfac- Base: Citric acid
tants 1% solu- 1% solution
tion pH = 10.5 pH = 3.0
IV
Inter-
mediate
inspection
70/158
1
P-W
-

3.05 DISPOSAL

Adhere to national regulations when disposing
of or recycling the product, its components or
its packaging.
proGAV ® 2.0 Tools
V VI
Thermal Drying
disinfec-
tion
94/201 90/194
10 40
P-W -
- -