Start Up Phase - ChefLine PYRALIS Manual De Instrucciones

FIRST LIGHTING OF THE OVEN
At the first use of the appliance it is advisable to heat the empty oven to eliminate bad smells caused by the
refractory stones evaporation and the inner metallic parts.
Procedure:
- fully open the exhauster valve;
- set the main switch in the position "1" after checking that the oven is connected with the power supply;
- heat up the heating elements by pushing the on/off switch on the digital control panel;
- leave the oven working (empty) for at least 8 hours at the temperature of 300° C before proceeding to
the first baking.

START UP PHASE

After connecting the oven to the electric net rotate the main switch (A) in position "1". The digital control
panel light on and the word off is shown on the display.
At this stage it is possible to start heating the oven by pushing the on/off touch, with the consequent the
heating elements start-up (top and bottom) of the baking chamber. By pushing the on/off touch a short
lamp-test takes place, after that for roughly 5 seconds the programme under process is shown (p1 or p2).
At this stage the display shows the average baking chamber temperature and the thermostat setting takes
place. This operation consists of the electronic and automatic use of the heating elements to reach and
maintain the temperatures set in the used programme (p1 or p2).
FUNCTION OF DIGITAL CONTROL PANEL
The main functions of the digital control panel are:
- visualization of the baking chamber temperatures (average top and bottom);
- top and bottom temperatures setting of baking programmes p1 or p2 (see ex. nr.1);
- baking timer setting and activation (see ex. nr 2);
- delayed switch-on setting and activation (see ex. nr 3).
- 60 -