Cover Latch Assembly; General; Right And Left Cover Latch Hooks; Right And Lefi Hook Guides - HP LaserJet II Serie Manual De Instrucciones

HP 33440/HP 33449 COMBINED SERVICE MANUAL
COVER LATCH ASSEMBLY
General
The DC Power Supply Assembly and High-Voltage Power Supply Assembly must be removed to
access the Hooks and Guides (see Figure 6-23). Note that the Right and Lefi Cover Latch Hook
assemblies are not interchangeable. The Cover Release Button is discussed in Section 6-2.
Right and Left Cover Latch Hooks
1.
2.
3.
Remove the Main Body Covers, Front Support Plate, DC Power Supply Assembly, and
High-Voltage Power Supply Assembly.
Remove the screw (1) and plate that secures the Right Hook and the screw (1) that secures the
Left Hook.
Pull the hooks &nd springs off the shti, being mrefil not to lose the springs.
To replace the hooks and springs, slide the spring onto the sh&, slide the hook onto the shti,
secure one end of the spring in its retaining position, and push the hook securely into position.
Then move the other end of the spring into its retaining position, as if closing a safety pin. Note
that thr right and lefi hook springs are different.
Right and Left Hook Guides
1.
Remove the Main Body Covers.
2. Remove the Right and Lefi Cover Latch Hooks according to the above procedure as needed.
3. Remove the screw (1) that secures each Hook Guide.
4. Lifi and slide the Hook Guides off the shti.
Note that the smaller diameter coil spring is instiled on the Lefi Hook Guide.
r
Right Hook
Guide
'ook~w
Hght Latch
Len Latch
rHook
Figure
6-23. Cover La!eb Assembly
6-28