Mirror Holder - HP LaserJet II Serie Manual De Instrucciones

\
HP 33440/HP 33449
MIRROR ASSEMBLY
COMBINED SERVICE MANUAL
1.
2.
3.
4.
5.
6.
Open the Top Cover Assembly and remove the EP-S Cartridge.
Remove the Mirror Shutier Assembly (3) or slide the shutier to the right past the lever and
swing it up and out of the way.
Note the orientation of the Mirror Assembly so it may be returned to the same position
(possibly mark the top of the mirror frame or note the lomtion of the formed part number).
Loosen the plastic frame (the EP-S Cartridge Guide) holding the Mirror and Erase Lamp
assemblies by removing the large upper screws (4 of 5) that secure the EP-S Cartridge Guide
Frame (see Figure 6-41) to the Top Cover Assembly.
Stide the Mirror Assembly stightiy to the right and lift it out the left side of the frame.
Ensure that the Mirror Assembly is returned to the printer in the correct orientation. The
assembly has a 6 mm slot on the left and an 8 mm slot on the right as shown in Figure 6-42.
If the mirror must be cleaned, use a so% dean, damp, fint-free wipe with a lens cleaning fluid
approved for camera lenses. See Chapter 4, Section 4-4, "Cleaning the Printer."
:
Figure 6-42. Mirror Holder
Note:
When returning the mirror to the cartridge
guide, be sure to orient it as shown below.
~ 6mm+~~— 1+8..
Lefi
Mirror Holder
Right
6-47