HP LaserJet II Serie Manual De Instrucciones página 354

HP 33440/HP 33449 COMBINED SERVICE MANUAL
set
up
to
use a serial
interface
Make
sure both
your computer and printer are turned off, and then
plug the cable into
your computer and
your printer.
Use
a small
screwdriver of necessary) to attach the cable to the printer. Note
into which serial port on your computer (e.g.,
COM1 or COM2) you
plug the cable; you will
need
this information later. When complete,
turn your printer and your computer ON again.
,,
10
—
I
Attach the serial cable connedor to
the serial 1/0 port on the back of the
ptinter. ~ou may need to use a small
screwdriver).
Step Press
Printer Displays: (If not, press + or- until it does,
and then press the Enter key.)
1
On Une
00 READY
(The On bne indicator goes out.)
2 Menu
(Hold down
for
AUTO CONT= OFF* ~
approximately 5
seconds.)
3
, Menu 1/0 = PARALLEL* ~
1
!
4 +
(Plus) or - (Minus) I
I;O=SERIAL
I
5
Enter I/O= SERIAL*
6
Menu
SERIAL= RS-232* t
7 Menu BAUD RATE =9600* ~
8
Menu ROBUST XON=ON*t
9 Menu DTR POLARITY= HI* ~
I
10
I
On Une I 00 READY
(The On Une indicator lights.)
I
+ Indicates the facto~ default.
If you are going to use serial RS-422 cable, refer to Appen&x F, .Interfaces", in the LaserJet Ill User's Manual (P/N 33449-90901 ).
B-14