Specifications; Overhead Transparencies - HP LaserJet II Serie Manual De Instrucciones

HP 33440/HP 33449: COMBINED SERVICE MANUAL
Face Sheet
Fusing
Compatibility
Construction
Ml adhesives, Eners, facestocks and other materials used in the label
construction must be compatible with the heat and pressure of the fusing
process. Materials must not discolor, melt, offset material or release
h~ardous emissions when heated to 200° C (392° F) for 0.1 seconds.
Toti construction diper must not exceed 0.0070 inches (0.18mm).
HP has tested labels-such as Ave~ labels specified for laser printers and Hewlett-Packard
LaserJet labels-and found their performance to be satisfactory.
Hewlett-Packard Labels (8 ~" x 11", 100 Sheets):
9
p/N
92296A
II:
x
2:**
p/N
92296F: ;II
x
l;II
Pfl g22g6B: l~!~ x 4]! P/N g22g6@ $*8x 3~*#
P/N g22g6C: 11(x 411 P/N g22g6H: 2~B* x 2~**
P/N g22g6D: 2*!x 4$! P/N
92296J: 1+11 x 411
P/N g22g6E: 3$ II x 4$s P/N g22g6K 8+11x 11~1
Caution
Remove each label immediately fier printing. Bemuse they may stick together
o
due to their heat retention properties, do not allow them to stack up in the paper
tray. Always use the Face-Up (Rear) Output Tray to prevent possible labeljams
and resultant damage to the printer.
Overhead Transparencies
Hewlett-Packard has tested overhead transparency film such as HP overhead transparencies and
found the performance acceptable. Use the rear output tray when printing transparencies to reduce
curl. Overhead transparencies should meet the specifications provided in Table 2-5.
Table 2-5.
Transparency Specifications
Thickness
0.100 to 0.110 mm 3.9 to 4.5 roils
Cutting Dimension Tolerance & 0.7
mm
0.031 inch
Cutting Angle 900 + 0.20
Hewlett-Packard offers the following overhead transparencies through its Direct Marketing
Division:
P/N 92296T: 8;" x 11", 50 Sheets
P/N 92296U: A4 (210 mm x 297 mm), 50 Sheets
2-12