Hints And Tips - Marshall JVM410H Manual Del Propietário

HINTS AND TIPS

FACTORY RESET
This will erase all the MIDI presets and set
MIDI reception channel to #1. Please note
that once the memory is erased it cannot
be recovered:
a) Switch the amplifier off (POWER switch
OFF).
b) Whilst pressing and holding the CLEAN
CHANNEL/ GAIN switch, switch the
amplifier on (POWER switch ON). The 4
channel LEDs will glow red.
c) Release the switch.
d) To confirm the factory reset press the
CRUNCH MODE switch.
e) If you want to abort the reset, press any
other key.
FOOTSWITCH RESET
To restore factory settings:
a) Unplug the footswitch at any of the
cable sides.
b) Press and hold switch #6 (right switch).
c) Plug in the footswitch cord.
d) Release the switch and the FX led will
start blinking.
e) If you want to erase the footswitch
memory press the switch #5. To keep
the memory press any of the #1 to #4
switches. Please note that once the
memory is erased it cannot be recovered.
f) Release the switch and the footswitch
will synchronise with the amplifier.
The factory default is as follows:
FSW #1: CLEAN
FSW #3: OD1
FSW #5: MASTER FSW #6: REVERB
HINTS
Hint 1:
It is possible to use different modes in the
same channel with different volumes to
avoid imbalance which can be especially
interesting in the CLEAN channel. To
do this simply create 2 presets in the
footswitch assigning MASTER 1 or
MASTER 2 to any of the modes. If you do
not connect any effect to the SERIAL /
PARALLEL FX LOOP the MIX control can
be used to act like an extra volume control
in any of the channels.
Hint 2:
To have a tuner output muting the
amplifier, connect the tuner to the FX
LOOP SEND and select the CLEAN
channel. Turn the MIX control to WET
and switch the FX LOOP on. Store this
preset as described before and label it
for example as 'tuner'. Obviously in this
configuration it is not possible to connect
any other effect to the FX LOOP.
Hint 3:
A note about using 2 heads simultaneously
– The suggested procedure is connect the
'master' head PREAMP OUT to the 'slave'
head POWER AMP IN and switch the
POWER AMP INSERT to ACTIVE in the
'slave' amplifier.
In order to track the MASTER volume
settings in both heads it is suggested to
use MIDI control with both amplifiers
programmed in the same way. Connect
the MIDI IN of one of the amplifiers to
the MIDI THROUGH of the other and
the pedalboard or MIDI equipment to the
remaining MIDI IN.
ENGLISH
FSW #2: CRUNCH
FSW #4: OD2