Compliance Statement; Technical Specifications - Marshall JVM410H Manual Del Propietário

COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance may void the users authority to operate the equipment.
This device complies with CAN ICES-3(B)/NMB-3(B)

TECHNICAL SPECIFICATIONS

Power (RMS)
Valves
Main Guitar - Input Impedance
Emulated Output - Level
FX Send Level - selectable
Weight
Size (mm) W, H, D
JVM410H Head
100W
5x ECC83 + 4x EL34
470kΩ
+4dBu
-10dBV, +4dBu
22kg
750 x 310 x 215
ENGLISH
JVM410C Combo
100W
5x ECC83 + 4x EL34
470kΩ
+4dBu
-10dBV, +4dBu
34.5kg
690 x 510 x 265