Recommended Unit Setting - Erbe 20132-106 Manual Del Usuario

OBJ_DOKU-189911-006.fm Seite 27 Donnerstag, 17. Juni 2021 9:31 09
3.11 Modification of the product by the user
Erbe Elektromedizin expressly warns against modifying the
product. Any modification exempts Erbe Elektromedizin from
any and all liability.
4

Recommended unit setting

4.1 For APC 300 in combination with a ICC 200, 300 or
350
• ICC 200: Argon Mode: 10 – 40 W
• ICC 300: Spray Coag: 10 – 40 W
• ICC 350: Spray Coag: 10 – 40 W
• APC 300: Argon flow is preset by instrument recognition.
4.2 For APC 2 in combination with a VIO
electrosurgical unit
After being connected to the APC 2, the instrument is detected
automatically and the instrument-specific display with basic set-
tings for the operating modes CUT and COAG is displayed on the
VIO electrosurgical unit.
If individual settings have been saved to the program for the op-
erating parameters mode, effect, rated power and/or argon
flow, these are displayed. Use the display on the VIO electrosur-
gical unit to make sure that the instrument has been correctly
detected.
27