Fuse; Connecting Main Power Cables - Vetus STE9524D Instrucciones De Instalación

Main switch with remote control
Instead of a storage battery main switch, a re-
motely controlled main switch annex emer-
gency stop can be installed.
6 .4

Fuse

In addition to the main switch, a fuse must be
included in the 'positive cable' .
The fuse prevents the bow thruster from
overloading, as well as protecting the on-
board network from short circuiting.
6 .5

Connecting main power cables

Make sure that no other electrical parts come loose when con-
necting the electric cables .
Check all electrical connections after 14 days . Electrical parts
(such as bolts and nuts) may come loose as a result of fluctua-
tions in temperature .
• Connect the main power supply cables.
Be careful not to rotate the bolt and nut 1 while connecting the
cables.
To prevent this happening, keep an open-ended spanner on nut
1 while screwing on bolt 2, without rotating this spanner.
The torque for nut 2 is 9 - 11 Nm (6.5 - 8 ft.lbf ).
vetus® Installation instructions Retractable Thrusters
This remotely controlled main switch is avail-
able for 12 or 24 Volt direct voltages.
Vetus art. code: BPMAIN12 respectively BP-
MAIN24.
See page 221 for the size of the fuse to be
used.
We can also provide a fuse holder for all types
of fuses. Vetus art. code: ZEHC100.
n
ote
Make sure that the voltage stated on the motor type plate is iden-
tical to the ship's power supply voltage .
See pages 220 and 221 for the applicable battery capacity, the size
of main power supply cables and fuse to use.
9 - 11 Nm
2
ENGLISH
n
ote
1
2 x M10 17
43
020584.01