Safety Warning; Safety Notes; General Safety Considerations - NAMCO PAC-MAN BALL Manual Del Usuario

No part of this publication may be reproduced by any mechanical, photographic or electronic process, or in the form of phonographic
recording, nor may it be stored in a retrieval system, transmitted or otherwise copied for private use, without permission from NAMCO
EUROPE LIMITED.
While the information contained in this manual is given in good faith and was accurate at the time of printing,
NAMCO EUROPE LIMITED reserve the right to make changes and alterations without notice.
This equipment has been manufactured in accordance with European Directives, and has been tested and complies with the
directives 89/336/EEC and 72/23/EEC by the application of EN55014-1, EN55014-2 and EN60335-2-82 standards and as such
bears the CE marking. Any changes or modifications to this equipment must be in accordance with the European Directives. Any
unauthorised changes to this equipment may contravene such directives.
Under some conditions of extreme external interference, e.g. radio transmissions, electrostatic discharge or mains born transients,
some degradation of performance may occur. However the equipment will recover normal performance once the source of
interference has ceased or been removed.
Following abnormally high surges on the mains supply, the video monitor may need to be manually reset by turning the equipment
OFF and back ON.
If the game processor resets due to an interruption of the mains voltage, any credits established will be lost.
This equipment is not a machine as defined by the machinery directive 89/392/EEC.
In order to use this equipment safely, be sure to read this Operators Manual carefully before installation, adjustment or use of this
equipment.
Whenever the owner of this equipment entrusts dis-assembly, installation, adjustment or routine maintenance to another person, the
owner should ensure that that person read the appropriate precautions and relevant sections of this manual before starting work.
In order that no accidents occur when the equipment is in operation, strictly follow the notes on safety as described
below.
This manual along with the Installation Manual (where applicable) form an integral part of the equipment and must be available to the
operating or service personnel at all times.
This equipment is for indoor use only and should only be used for the purpose intended.
Namco Europe Ltd. bears no responsibility for accidents, injury or damage resulting from unauthorized changes to, or improper use
of this equipment.
The following safety notes are used throughout this manual. Familiarize yourself with each of these notes and it's meaning before
installing, servicing or making adjustments to this equipment.
l
WARNING Warning denotes a hazard that could result in injury or death. Do
indicated conditions are fully understood and met.
i
CAUTION Caution denotes a hazard that could result in damage to the equipment. Do not proceed beyond a caution note
until the indicated conditions are fully understood and met.
l
Only operate this equipment after checking that it has been installed correctly and in accordance with this manual.
l
Installation, service, adjustment or routine maintenance should be carried out by suitably qualified persons only.
l
For continued protection against fire hazard, replace fuses with the same type and rating. The use of other fuses or
material is prohibited.
l
To prevent possible electric shock due to failure, this equipment MUST be fitted with a securely connected
EARTHED plug.
l
If at any time the mains lead becomes damaged, it must be replaced immediately.
l
Do not turn the power switch ON until the equipment has ben installed correctly.
i
Before connecting the machine to the mains supply, ensure that the equipment is set for the correct voltage and that the
correct fuse are fitted.
�

SAFETY WARNING

SAFETY NOTES

GENERAL SAFETY CONSIDERATIONS

Page 6
not proceed beyond a warning note until the