Replacing The Divider Solenoids - NAMCO PAC-MAN BALL Manual Del Usuario

7-7-4-3

Replacing the Divider Solenoids

The following describes the procedures for removing and re-installing the Coin
Selector (R) Assy. Follow the same procedures for the removal of Coin Selector
(L).
1. Remove the Coin Selector (R) Assy.
2. Disconnect the connector, remove 1off pozi head screw (M4x6) and
remove the Sensor Holder (R).
3. Remove the spring.
Solenoid mounting direction
4. Disconnect the connector remove 4off pozi head screws (M3x6).
5. Remove 1off Spring Pin (3x1.5), disengage the joint, and replace the
Divider Solenoid (R).
6. Re-assemble in reverse order.
• When re-assembling, take note of the direction of the Solenoid
Harness.
Solder holder (R)
Note solenoid mounting direction
Divider solenoid (R)
Spring pin A (3 x 15)
Pozi head screws (M3 x 6)
Page 124
(see 7-7-1 page 119)
Pozi head screw (M4 x 6)
Connector
Joint
Spring