Replacing The Lock-Out Solenoids - NAMCO PAC-MAN BALL Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
7-7-3

Replacing the Lock-Out Solenoids

The following describes the procedures for removing and re-installing the Coin
Selector (R) Assy. Follow the same procedures for the removal of Coin Selector
(L).
1.
Remove the Coin Selector (R) Assy.
2.
Disconnect the connector.
3.
Remove the Twin-Sensor Holder.
Connector
4.
Remove 2off pozi head screws (M3x4) and remove the Lock-Out Solenoid.
5.
Remove 1off Spring Pin (2x10), and remove the Plunger.
6.
Replace the Solenoid.
Pozi head screws (M3 x 4)
7.
Re-assemble in reverse order.
(see 7-7-1 page 119)
(see 7-7-2 page 120)
Plunger
Spring pin A (2 x 10)
Page 121
Twin-sensor holder
Lock-out solenoid

Publicidad

Tabla de contenido
loading

Tabla de contenido