Replacing The Wiper Motor - NAMCO PAC-MAN BALL Manual Del Usuario

7-4-5

Replacing the Wiper Motor

• Do not turn the Wiper Motor by hand. Doing so can damage the
internal gears.
1 Remove the maintenance panel from the rear of the cabinet.
2. Disconnect the connector, remove 4off snap pins and 8off flat washers
(M5).
3. Remove 4off whizz nuts (M4), and remove the Wiper Motor with Bracket.
Wiper motor bracket
4. Remove 1off snap pin, 2off flat washers (M6), and remove the Wiper Link
Plate.
Whizz nuts (M4)
Snap pins,
flat washers (M5)
Whizz nuts (M4)
Snap pin
Washer (M6)
Page 113
Connector
Snap pins,
flat washers (M5)
Wiper link plate