7-7-4
Coin Divider (L), (R) Assys
7-7-4-1
Removing the Coin Divider (L), (R) Assys
The following describes the procedures for removing and re-installing the Coin
Selector (R) Assy. Follow the same procedures for the removal of Coin Selector
(L).
1.
Remove the Coin Selector (R) Assy.
2.
Disconnect the connector, remove 2off Whizz nuts (M4), and remove the
Coin Divider (R) Assy.
Connector
Coin Divider (R) Assy
[Correct assembly]
3.
Re-assemble in reverse order.
•
When re-assembling, ensure that the harness near the connector does
not block the coin passage or contact the inside of the Coin Divider
(L), (R) Assy.
(see 7-7-1 page 119)
Whizz nuts (M4)
[Improper assembly]
Harness
Page 122
Coin Selector (R) Assy
Coin passage