Cleaning And Maintenance; General Recommendations; Cleaning; Preventive Maintenance - Stryker 0240-031-050 Manual Del Usuario

Cleaning and Maintenance

Warning
To avoid electric shock and potentially fatal injury, unplug the display and power supply
from the electrical outlet before cleaning.
Caution
• Do not spray cleaning liquid directly onto the display or the power supply as product
damage may result. Spray on the cloth before wiping the unit.
• Do not immerse the display or power supply in any liquid as product damage will
result.
• Do not use corrosive cleaning solutions to clean the display or power supply as
product damage may result.
• Do not sterilize the display or power supply as product damage may result.

General Recommendations

• Keep the display clean to prolong its operational lifetime
• LCD panel performances may deteriorate in the long-term. Periodically check that it is
correctly operating.
• Periodically check the tightness of the VESA mount screws. If not sufficiently tight, the
display may detach from the arm, which may result in injury or equipment damage.

Cleaning

Note: Take extra care when cleaning the display screen. Excess liquid or drips that enter the
bottom of the screen or the power supply receptacle may result in product damage.
To clean the display or the power supply:
1. If the display cover is in place, remove the cover prior to cleaning.
2. Apply standard disinfectant or mild detergent to a dry sterile cloth.
3. Wipe the display or power supply.
4. Visually inspect the external surface of the device for cleanliness, focusing on hard-to-reach
areas. If visible soil remains, repeat steps 1 – 3.

Preventive Maintenance

With the display disconnected from mains perform the following periodical check:
• Check the integrity of the power cord and inspect its routing, so that it is not under the risk
of being punched or cut.
• Clean the area around the power plug, dust and liquids may result in fire.
• Clean the ventilation slot of the display, dust can obstruct the air flow and cause temperature
increase of the electronics.
EN-20