Limitation Of Liability; Requirements For Skilled Persons And Operating Personnel - SICK PowerProx Micro WTT2SL Manual Del Usuario

2.5

Limitation of liability

2.6

Requirements for skilled persons and operating personnel

8021879.1CXK /2021-09-20 | SICK
Subject to change without notice
NOTICE
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
The device should be used only in line with intended use specifications.
b
All information in these operating instructions must be strictly complied with.
b
Applicable standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when
assembling the data and information contained in these operating instructions. The
manufacturer accepts no liability for damage caused by:
Failing to observe the operating instructions
■
Improper use
■
Use by untrained personnel
■
Unauthorized conversions
■
Technical modifications
■
Use of unauthorized spare parts, consumables, and accessories
■
With special variants, where optional extras have been ordered, or owing to the latest
technical changes, the actual scope of delivery may vary from the features and illustra‐
tions shown here.
WARNING
Risk of injury due to insufficient training.
Improper handling of the device may result in considerable personal injury and material
damage.
All work must only ever be carried out by the stipulated persons.
■
The operating instructions state the following qualification requirements for the various
areas of work:
Instructed personnel have been briefed by the operating entity about the tasks
■
assigned to them and about potential dangers arising from improper action.
Skilled personnel have the specialist training, skills, and experience, as well as
■
knowledge of the relevant regulations, to be able to perform tasks assigned to
them and to detect and avoid any potential dangers independently.
Electricians have the specialist training, skills, and experience, as well as knowl‐
■
edge of the relevant standards and provisions to be able to carry out work on
electrical systems and to detect and avoid any potential dangers independently. In
Germany, electricians must meet the specifications of the BGV A3 Work Safety
Regulations (e.g., Master Electrician). Other relevant regulations applicable in
other countries must be observed.
The following qualifications are required for various activities:
Tasks
Mounting, maintenance
Qualification
Basic practical technical training
■
Knowledge of the current safety regulations in the workplace
■
O P E R A T I N G I N S T R U C T I O N S | PowerProx Micro - WTT2SL(C)
SAFETY INFORMATION
2
en
23