Cleaning The Device - SICK PowerProx Micro WTT2SL Manual Del Usuario

8
MAINTENANCE
8.2

Cleaning the device

en
30 O P E R A T I N G I N S T R U C T I O N S | PowerProx Micro - WTT2SL(C)
Table 8: Maintenance schedule
Maintenance work
Clean housing and front screen
Check screw connections and plug
connectors
At regular intervals (e.g., weekly), check the light emission window and the housing of
the device for dirt. This is especially relevant in harsh operating environments (dust,
abrasion, damp, fingerprints, etc.). The lens of the light emission window must be kept
clean and dry during operation.
NOTICE
Device damage due to improper cleaning!
Improper cleaning may result in device damage.
Only use suitable cleaning agents.
■
Never use sharp objects for cleaning.
■
Cleaning the light emission window
NOTICE
Damage to the light emission window!
Reduced reading performance due to scratches or streaks on the light emission win‐
dow!
Clean the light emission window only when wet.
b
Use a mild cleaning agent that does not contain powder additives. Do not use
b
aggressive cleaning agents, such as acetone, etc.
Avoid any movements that could cause scratches or abrasions on the light emis‐
b
sion window.
Only use cleaning agents suitable for the screen material.
b
NOTE
Static charge may cause dust particles to stick to the light emission window. This effect
can be avoided by using an anti-static glass cleaner in combination with the SICK lens
cloth (can be obtained from www.sick.com).
NOTE
If the light emission window is scratched or damaged (cracked or broken), the device
must be replaced. Contact SICK Service to arrange this.
Cleaning the housing
In order to ensure that the heat produced by the internal power loss is adequately
dissipated, the housing surface must be kept clean.
Interval
Cleaning interval depends on ambi‐
ent conditions and climate
Every 6 months
Implementation
Specialist
Specialist
8021879.1CXK /2021-09-20 | SICK
Subject to change without notice