On-Line Operation - Rollei 58 Instrucciones

Complete Setup
62
After set up press again the "Parameter Settings Button" to exit the set status . The
FEB settings can not be changed afterwards .
On-line Operation (mounted on camera)
Flash TTL Mode
If the flash is connected to a Canon camera through the hot shoe, the screen of the
flash will show E-TTL to represent the current metering system .
If the flash is connected to a Nikon camera through the hot shoe, the screen of the
flash will show i-TTL to represent the current metering system .
The Nikon system does not support flash on FEB settings . To realize surrounded the
exposure function on Nikon (BKT), please refer to the camera settings .
Flash Exposure Lock (FEL/FV)
The „Flash Exposure Lock" locks the correct flash
exposure setting for any part of the scene . When
<TTL> is displayed on the panel, please connect
the flash to your camera correctly . For Canon came-
ras press the "FEL" or "*" (AEL auto exposure lock)
button . For Nikon cameras press "FV" button . Then
the flash will do a preflash and the camera will
calculate the appropriate flash output . At this point
you have time for re-composition . After finishing
you can press the shutter release for shooting pic-
tures . (This feature requires you to use the camera
support itself, therefore please refer to your camera
manual settings) .
ENGLISH