Automatic Save Function; Bounce Flash - Rollei 58 Instrucciones

Automatic Save Function

88
After flash has been set up, but for 5 seconds no buttons are pressed, the flash will
automatically save the current settings . It is convenient for next time operation .
Reset All Settings to Factory Default Settings
If you need to clear the changes on the flash,
restore the factory default settings . Therefore press
the "parameter settings button" and "High speed
/Rear curtain/Ordinary flashlight switch button"
at the same time . Then the flash will restore the
default settings .
Flash Lock (Low Power Tips)
When the battery power is low or other reasons
cause flash charging is not completed within the
time limit, the flash will enter a state of lock .
Meanwhile the screen shows a battery sign like
shown in the figure and it will make signal tone
that reminds the user to replace the battery .

Bounce Flash

If the flash head is pointed to the wall or ceiling, the flash will be reflected by the
wall . If this is illuminating then the subject, this can help to reduce shadows around
the subject and get more natural effects .
ENGLISH