Rear Curtain Sync - Rollei 58 Instrucciones

Rear Curtain Sync

With a slow shutter speed a light trail following
the subject can be created . Therefore the flash fires
just before the shutter closes .
1 . If the Flash Unit is used with a Canon camera
under e-TTL or M mode:
If you want to use the high-speed sync / Rear-curtain sync function correctly,
press the <High-speed sync/Rear-curtain sync/ordinary flashlight> button to
open the corresponding function –> high speed synch
sync .
2 . If you are using a Nikon camera, you cannot directly set the high-speed synchro-
nous mode in the Flash Unit . This needs to be done by the camera menu which
needs to be set to "FP" . When the flash is connected to the camera, the display
shows immediately . For the rear-curtain synch this needs to be done in the
same way as for the high-speed synch (there is nothing shown on the Flash
Unit's display) .
Off-Camera High Speed Synchronous (not mounted on camera):
Within the wireless SLAVE mode the flash can receive a high speed synchronous
signal from the MASTER flash .
Note: To use the high-speed sync/Rear-curtain sync correctly the camera flash
mode and shutter speed needs to be set properly .
High-speed synchronization off the machine
can be achieved in two ways:
1 . Wireless TTL trigger (The trigger needs to support high speed synchronization)
2 . Set the Flash Unit to SLAVE c or SLAVE n mode
–> Rear-curtain
67