Bahco TASMB Serie Traducción De Las Instrucciones Originales página 11

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH
STD
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
SLIM
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
Note: When using a negative offset, entering a target torque greater than maximum values
above may cause an overtorque error before reaching fastener target torque and possibly
damage wrench.
VIEWING STORED TORQUE AND ANGLE DATA
Torque data is stored in memory after each torque cycle if applied torque has reached target value.
Torque and angle data is stored in memory after each angle cycle if applied angle has reached target
value. Memory Indicator is displayed when data is stored in non-volatile memory.
1. To view stored torque and angle data, from target torque or angle screen, press and hold ENTER
button for 3 seconds.
2. Highlight SHOW DATA menu selection by pressing UP/DOWN buttons then press ENTER button to
display Show Data screen.
3. In Show Data screen, scroll through each stored data record by pressing UP/DOWN buttons.
Example:
0002 = Show Data List Counter: TQ = Peak torque value
0001 = Show Data List Counter: TQ = Peak torque value: ANG = Peak angle value
4. Pressing ENTER button while on Show Data screen returns to main menu.
®
SCREWDRIVER
334
328
322
316
792
785
777
770
28.70
27.40
26.10
24.80
® WRENCH
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
642
634
626
618
131
126
122
118
11