Bahco TASMB Serie Traducción De Las Instrucciones Originales página 41

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH
SLIM
Note: Maximum value for warning and lock counts is 5000.
Note: If Enable Cal Count is disabled, warning count and lock count are set to zero and a CAL
NEEDED message is not displayed by cal cycle count.
Note: If warning count is set to zero and lock count is non-zero, CAL NEEDED screen is
displayed when cal cycle count reaches lock count and no warning count is displayed.
Note: If warning count is set to non-zero and lock count is zero, CAL NEEDED screen is
displayed when cal cycle count reaches warning count and wrench does not lock.
Note: If both warning count and lock count are non-zero, CAL NEEDED screen is displayed
when cal cycle count reaches warning count and number of cycles until lock count is displayed:
Note: If cal cycle count reaches non-zero lock count, applying torque immediately turns on red
LEDs and vibrator. If ENTER button pressed, password screen is displayed:
SETTING CALIBRATION INTERVAL
This function allows user to set calibration interval for when "CAL NEEDED" message will be displayed.
ENTER button.
2. CAL INTERVAL screen is displayed.
3. Use UP/DOWN buttons to change calibration interval.
Selectable Intervals:
• 12 MON (factory default)
® WRENCH
®
SCREWDRIVER
41