Bahco TASMB Serie Traducción De Las Instrucciones Originales página 17

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH
torque is reached if a batch count of zero is entered. Mode Count decrements if a non-zero batch
count is entered and resets to batch count value when count reaches zero. Once desired batch
count value has been set, press ENTER button.
8. PSET target screen is displayed labeled with next available PSET number from 01 to 10.
9. To enter additional torque presets, repeatedly press ENTER button until target torque screen is
displayed and repeat steps above.
STD
SLIM/SCR
ADDING AN ANGLE PRESET
1. From manual target angle screen, press and hold UNITS button for 3 seconds.
then press ENTER button. NO menu selection returns to main menu without adding a PSET.
3. TARGET ANGLE screen is displayed. TARGET ANGLE is fastener rotational angle target value.
Initial TARGET ANGLE value is value from target angle screen. TARGET ANGLE can be set from 0
to 360° by pressing UP/DOWN buttons. Once desired target angle value has been set, press ENTER
button.
4. MINIMUM ANGLE screen is displayed. MINIMUM ANGLE is value at which green progress lights, audi-
ble alert and vibrator turn on. Initial MINIMUM ANGLE value is value from target angle screen. MINIMUM
ANGLE can be set from 0 to 360º by pressing UP/DOWN buttons. Once desired minimum angle value
has been set, press ENTER button.
5. MAXIMUM ANGLE screen is displayed next. MAXIMUM ANGLE is angle value above which red pro-
gress lights turn on. Initial MAXIMUM ANGLE value will be MINIMUM ANGLE plus 4%. MAXIMUM AN-
GLE value can be set to any value greater than MINIMUM ANGLE by pressing UP/DOWN buttons. Once
desired value has been set, press ENTER button.
® WRENCH
®
SCREWDRIVER
17