Calibration Menu - Bahco TASMB Serie Traducción De Las Instrucciones Originales

TASMB AND TAWMB SERIES

CALIBRATION MENU

Calibration menu is passwork protected. Refer to Calibration manual.
STD
SLIM
Calibration Menu Selections:
• CAL TORQUE – Torque Calibration function (Refer to ControlTech™ Micro Wireless Calibration manual).
• CAL ANGLE – Angle Calibration function (Refer to ControlTech™ Micro Wireless Calibration manual).
manual).
• SET CAL DATE – Displays Set Calibration Date screen.
• CAL CYCLE CNT – Displays Calibration Cycle Count.
• CYCLE COUNT - Displays torque/angle cycle count screen.
• ENABLE CAL CNT – Enable Calibration Needed Warning Cycle Count and Lock Cycle Count.
• SET CAL INTRVAL – Displays Set Calibration Needed interval screen.
• CAL COUNTDOWN – Displays Set Calibration Needed warning days before lockout screen.
expired and/or when a number of torque cycles have been completed. Wrench can be set to lock out
any more torque cycles until wrench is re-calibrated.
SETTING CALIBRATION DATE
1. If a wrench does not require re-calibration, Set Calibration Date function allows user to set
Calibration Date used to calculate CAL NEEDED interval.
2. From Calibration menu, use UP/DOWN buttons to highlight SET CAL DATE selection then press
ENTER button.
3. SET DATE screen is displayed with year highlighted.
4. Use UP/DOWN buttons to set year then press ENTER button to highlight month.
5. Use UP/DOWN buttons to set month then press ENTER button to highlight day.
6. Use UP/DOWN buttons to set day then press ENTER button.
7. Clock is set and Calibration menu is displayed.
Note: Year selection will scroll up from 2018. Month selection will scroll from 01 through 12 and
roll over from 12 to 01 and down from 01 to 12. Day selection will scroll from 01 through 31 and
roll over from 31 to 01 and down from 01 to 31.