Bahco TASMB Serie Traducción De Las Instrucciones Originales página 40

TASMB AND TAWMB SERIES
SLIM
Note: Cal Cycle Count is automatically reset to zero when wrench is recalibrated.
Note: If wrench does not require calibration and SET CAL DATE function is used to update
calibration date, Cal Cycle Count should be manually cleared.
ENABLE CALIBRATION COUNT
This function allows user to enable number of calibration cycles before CAL NEEDED message is
displayed on wrench. When enabled, a calibration warning count can be set to display number of cycles
left before wrench should be calibrated. A calibration lock count can be set to lock wrench from any
more use when lock count is reached.
1. From Calibration Menu, select ENABLE CAL CNT, press ENTER button.
2. From ENABLE CAL CNT screen, press UP/DOWN buttons to select ENABLE.
3. From WARNING COUNT screen, press UP/DOWN buttons to set cycle count value, press ENTER
button.
4. From LOCK COUNT screen press UP/DOWN buttons to set lock cycle count value, press ENTER
button.
STD