Bahco TASMB Serie Traducción De Las Instrucciones Originales página 3

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH
• Never use this tool to break
fasteners loose.
• Do not use extensions, such
as a pipe, on handle of tool.
• Check that tool capacity
matches or exceeds each
application before proceeding.
• Verify calibration if dropped.
• Make sure ratchet direction
lever is fully engaged in correct
position.
• Verify calibration of tool if you
know or suspect its capacity
has been exceeded.
•
drives against stops.
• Always adjust your stance to
prevent a possible fall should
something give while using
tool.
• Do not attempt to recharge
Alkaline cells.
• Store tool in dry place.
• Remove batteries when storing
tool used for periods longer
than 3 months.
® WRENCH
®
SCREWDRIVER
WARNING.
Do not use on live electrical
circuits.
SAVE THESE INSTRUCTIONS
DISCLAIMER
Operation of the tool is not
warranted in an EU member
state if operating instructions
are not in that State's language.
Contact BAHCO if a translation
is needed.
3