Bahco TASMB Serie Traducción De Las Instrucciones Originales página 8

TASMB AND TAWMB SERIES
3. Apply TORQUE.
Grasp center of handle and slowly apply torque to fastener until progress lights display green and a
½ second audible alert and handle vibration alerts you to stop.
4. Release TORQUE.
pressing UP/DOWN, ENTER or UNITS button will immediately return to target TORQUE screen.
Reapplying TORQUE will immediately start another TORQUE measurement cycle.
5. Recall Peak TORQUE Reading.
To recall last peak TORQUE measurement, press and hold BACKLIGHT button for approximately 3
ANGLE MODE
ZERO REQUIRED" message is displayed. After two seconds angle zero process begins and tool
must be placed on a stable surface. If ENTER button is pressed before two seconds to change
to torque only mode, angle zero process is skipped.
1. Set target. Use UP/DOWN buttons to change target ANGLE value.
2. Apply Torque and Rotate Tool. Grasp center of handle and slowly apply torque to fastener and rotate
tool at a moderate consistent speed until progress lights display green and a ½ second audible alert
and handle vibration alerts you to stop.
until button is released. Momentarily pressing UP/DOWN, ENTER or UNITS button will immediately
return to target ANGLE screen. Reapplying torque (ratcheting) before target screen is displayed will
continue ANGLE accumulation as tool is rotated.
4. Recall Peak ANGLE Reading. To recall last peak ANGLE measurement, press and hold BACKLIGHT
button for approximately 3 seconds. Peak TORQUE and ANGLE will be displayed alternately for 5 seconds.
MODE CYCLE COUNT
Mode cycle count feature is used to indicate number of times tool has reached target torque in torque
measurement mode or target angle in angle measurement mode.
STD / SLIM / SCR
180º
M
MEMORY icon
TORQUE AND ANGLE MODE CYCLE COUNTING
1. Numerical counter located in top right of target torque or target angle screen will increment after each
torque or angle cycle if applied torque or angle has reached target value.
2. When toggling between torque mode or angle mode using ENTER button or if target is changed,
numerical counter will reset back to 00. counter WILL NOT reset when re-zeroing, on menu entry/
exit or power down.
3. Memory icon will turn on indicating at least one torque or angle cycle data has been stored in
memory.
01
MODE CYCLE COUNT