Bahco TASMB Serie Traducción De Las Instrucciones Originales página 31

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH ® WRENCH
®
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH SCREWDRIVER
STD
SLIM
Note: UNITS button can be used to select torque units while on Torque THEN Angle screen.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red progress lights turn on if torque exceeds 110% of tool full scale or if angle exceeds
target + plus tolerance while in manual mode.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while
on Torque THEN Angle screen. MAXIMUM TORQUE defaults to full range plus 10%. Refer to
ENABLE/DISABLE TORQUE AND ANGLE MODE
This function will allow user to enable or disable Torque AND Mode.
1. From Mode Setup menu, use UP/DOWN buttons to highlight AND DISABLED (factory default)
selection then press ENTER button.
2. TQ AND ANGLE enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or DISABLE selection.
4. Press ENTER button to accept selection and exit to Mode Setup menu.
STD
31