Rear Wheel - APRILIA SCARABEO50 I.E.-100 4T Manual Del Usuario

REAR WHEEL

DISASSEMBLY
CAUTION
The disassembly and reassembly opera-
tions of the rear wheel may result diffi-
cult and complicated for an unskilled op-
erator. Contact an aprilia Official Dealer
if necessary.
If you wish to perform this operation per-
sonally, follow the steps below.
Carefully read page 47 (MAINTENANCE).
Before performing the following opera-
tions, allow the engine and silencer to
cool down to the ambient temperature in
order to avoid burns.
On disassembly and reassembly of
the wheel, be careful not to damage the
pipeline, disc and brake pads.
♦
Position the vehicle on the centre stand,
on a solid and level surface.
♦
Remove the silencer, see page 66 (RE-
MOVING THE EXHAUST SILENCER).
♦
Remove the cover (1).
use and maintenance Scarabeo 50
60
All manuals and user guides at all-guides.com
2
1
NOTE
To be able to unloose the wheel nut
(2) it is necessary to block the wheel.
♦
Completely pull the rear brake lever (3),
interposing a card (4), and keep it pulled
by means of a plastic clamp (5).
♦
Unscrew and remove the wheel nut (2) and
the washer.
NOTE
Upon reassembly, change the wheel
nut (special type).
Wheel nut (2) driving torque:
110 Nm (11 kgm).
♦
Release the rear brake lever.
♦
Unloose the splash guard, see page
100
57.
♦
Withdraw the wheel.
100
♦
Remove the rear brake caliper, see
page 64 (REMOVING THE REAR BRAKE
CALIPERS ).
- Scarabeo 100 4T
100
2
1
♦
NOTE
only.
♦
After reassembly, make sure that the fol-
lowing components are not dirty:
– tyre;
– wheel;
–
After reassembly, pull the rear brake le-
ver repeatedly and check the correct func-
tioning of the braking system. Check the
wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
aprilia Official Dealer, in order to avoid
accidents that may be harmful for you and/
or other people.
3
5
Withdraw the wheel.
Use aprilia Genuine Spare Parts
brake discs.
CAUTION
4