Front Wheel - APRILIA SCARABEO50 I.E.-100 4T Manual Del Usuario

100
1
1

FRONT WHEEL

DISASSEMBLY
CAUTION
The disassembly and reassembly opera-
tions of the front wheel may result diffi-
cult and complicated for an unskilled
operator.
Contact an aprilia Official Dealer if nec-
essary.
If you wish to perform this operation per-
sonally, follow the steps below.
Carefully read page 47 (MAINTENANCE).
Upon disassembly and reassembly of the
wheel, be careful not to damage the pipe-
line, discs and brake pads.
use and maintenance Scarabeo 50
58
All manuals and user guides at all-guides.com
aprilia
3
♦
Position the vehicle on the centre stand,
on a solid and level surface.
NOTE
Arrange for a support with a base
of 200x200mm and suitable height.
♦
Place the support under the vehicle and a
spongy cloth between them, so that the
front wheel can move freely and the vehi-
cle cannot fall down.
Make sure that the vehicle is stable.
♦
Put a suitable support (1) under the tyre to
hold the wheel in the right position, after
releasing it.
♦
Unloose screw (2) of the wheel pin clamp.
♦
Completely unscrew the wheel pin (3).
Wheel pin-nut driving torque:
50 Nm (5.0 kgm).
- Scarabeo 100 4T
6
4
2
CAUTION
♦
Hold the front wheel and manually remove
the wheel pin (3).
♦
Keep the washer (4).
CAUTION
Do not actuate the front brake lever after
removing the wheel to prevent the caliper
pistons from falling out of their seats,
causing the brake fluid to leak out.
In this case, contact an aprilia Official
Dealer that will carry out the required
maintenance operations.
♦
Move the front wheel forward until the disc
can be removed from the brake caliper (5).
♦
Remove the front wheel.
♦
Disable the odometer transmission (6).
5