Removing The Footboard; Checking The Stand - APRILIA SCARABEO50 I.E.-100 4T Manual Del Usuario

3
1
2

REMOVING THE FOOTBOARD

Carefully read page 47 (MAINTENANCE).
♦
Remove the inspection cover, see page 65
(REMOVING THE INSPECTION COVER).
♦
Unloose and remove the two screws (1).
♦
Unloose and remove the three screws
(2) located under the footboard.
CAUTION
Proceed with care to avoid damaging the
tangs and/or relevant seats.
♦
Slightly lift the rear part of the footboard
(3) and withdraw it from the base of the
inner shield.
use and maintenance Scarabeo 50
68
All manuals and user guides at all-guides.com
1
Do not force the lower shield as it is fixed
to the frame with only two front screws.
NOTE
On reassembly, first insert the two
central tangs and then the side tangs. Be-
fore you insert the three screws (2), visually
check that the footrest - screw holes are
aligned.
- Scarabeo 100 4T
CAUTION
100
2
1

CHECKING THE STAND

Carefully read page 47 (MAINTENANCE).
Make sure the stand (1) rotates freely.
Perform the following checks:
♦
The springs (2) must not be damaged,
worn, rusty or weak.
♦
The stand must rotate freely. If necessary,
grease the articulated joint, see page 90
(LUBRICANT CHART).
2
1