Receiving The Product; Transporting The Product; Unpacking The Product; Inspecting The Product - Grundfos CR Serie Instrucciones De Instalación Y Funcionamiento

2. Receiving the product

2.1 Transporting the product

WARNING
Falling objects
Death or serious personal injury
- Keep the product in a stable and fixed
position during transportation.
- Wear personal protective equipment.

2.2 Unpacking the product

WARNING
Falling objects
Death or serious personal injury
- Keep the product in a stable position
during unpacking.
- Wear personal protective equipment.

2.3 Inspecting the product

Before you install the product, do the following:
1. Check that the product is as ordered.
2. Check that no visible parts have been damaged.
If parts are damaged or missing, contact your local
Grundfos sales company.

2.4 Lifting the product

WARNING
Falling objects
Death or serious personal injury
- Follow the lifting instructions.
- Use lifting equipment which is approved
for the weight of the product.
- Persons must keep a safe distance to
the product during lifting operations.
- Wear personal protective equipment.
Note that typically the centre of gravity of
the pump is close to the motor.
When lifting the entire product with motor, follow
these instructions:
• Pump with motor sizes 0.37 - 5.5 kW:
Lift the pump in the motor flange by means of
straps or the like.
• Pump with motor sizes 7.5 - 22 kW:
Lift the pump by means of the motor eyebolts.
• Pump with motor sizes 30-45 kW:
Lift the pump by means of the lifting brackets on
the motor flange.
• Pump with motor sizes 55-75 kW:
Lift the pump by means of the eyebolts on the
motor side.
0.37 - 5.5 kW
30-45 kW
Fig. 1 Lifting points
In case of CR, CRI and CRN pumps with other
motors than MG or Siemens, we recommend that
you lift the pump by means of the straps in the motor
flange.
7.5 - 22 kW
55-75 kW
3