Tensioning The V-Belt - Stihl TS 510 Cutquik Manual De Instrucciones

A
1
For outboard mounting,
: secure adjustable handle (1) in
position A.
TS 510, TS 760

Tensioning the V-belt

2
9
: Unscrew the hexagon bolts (2) and
slightly tighten the rear bolt (with
segment).
: Use the combination wrench to turn
the tensioning segment (9)
clockwise until the belt is correctly
tensioned.
: Then retighten the hexagon bolts,
starting with the bolt at the rear (with
segment), using the combination
wrench.
The V-belt is correctly tensioned
when it can be slightly depressed
(5 to 10 mm) in the middle between
the V-belt pulleys when lightly
pressed with the fingers.
Excessive wear will result if the
V-belt is overtensioned.
The V-belt tension must be checked
2
after approx. one hour of operation and
corrected if necessary on new machines
2
and when a new V-belt has been fitted.
English / USA
19